Fisher & Paykel CDV2 Series User Manual page 10

OFF
HI
1 Identify the knob of the burner you
want to use.
3 After the burner has lit, adjust the flame
anywhere between HI and SIM.
Do not adjust or leave the knob
●
between HI and OFF.
IMPORTANT!
Turn the burner OFF and see
'Troubleshooting' for what to do next if
you experience any of the following:
There's a strong gas smell.
●
The flame has been blown out by a draft
●
or extinguished by a spill and does not
re-ignite.
There is no clicking/sparking or there is
●
clicking/sparking, but a burner or burners
won't light.
USING YOUR COOKTOP
Burner
indicator
SIM
2 Press down then turn counter-clockwise
to HI.
The ignitors start clicking as they spark.
●
CDV2-365H/304H models only:
All the halos will glow white.
●
Once the burner lights, the halo will
●
glow orange.
If there is no clicking, there is no spark
●
to light the burner. If the burner fails to
light turn the knob back to OFF and see
'Troubleshooting'.
4 When you have finished cooking, turn the
knob clockwise back to OFF.
CDV2-365H/304H models only:
If you have other burners on:
The halo will glow white.
●
If you don't have any other burners on:
All the halos will go out.
●
Check that the burner has gone out.
●
Before leaving the kitchen, check that
●
all burners have been turned off.
The flames don't burn all the way
●
around a burner, or some flames flicker.
The flame is yellow or yellow-tipped
●
rather than blue.
The flames are too large, small, irregular,
●
noisy or lift away from the burner.
EN
Halo
(Orange)
-H models
only
9