Schumacher SPI1224 Owner's Manual page 10

RECONDITION TIME REMAINING XXX MINUTES – Recondition mode has started. The
remaining time on the display counts down from 180 minutes.
RECONDITION SUCCESSFUL-START NORMAL CHARGING – Shows on display for
60 seconds after a successful Recondition.
WARNING-CLAMPS REVERSED (No LED lit) – The output clamps are connected
backwards to a battery.
ANALYZING 12V BATTERY (Green LED lit) – Plugged into the AC outlet, and when first
correctly connected to 12V battery at 12V charge mode.
ANALYZING 24V BATTERY (Green LED lit) – Plugged into the AC outlet, and when first
correctly connected to 24V battery at 24V charge mode.
CHARGING 12V – xx% (Green LED lit) – Plugged into the AC outlet and correctly
connected to a discharged 12V battery at 12V charge mode.
CHARGING 24V – xx% (Green LED lit) – Plugged into the AC outlet and correctly
connected to a discharged 24V battery at 24V charge mode.
FULLY CHARGED-AUTO MAINTAINING (Green LED pulsing) – Plugged into the AC
outlet and correctly connected to a fully charged battery.
CHARGE ABORTED-BAD BATTERY (Green LED flashing) –
Circumstances that could cause an Abort situation during charging:
• The battery is severely sulfated or has a shorted cell and can't reach a full charge.
• The battery is too large or there is a bank of batteries and it doesn't reach full charge within
a set time period.
Circumstances that could cause an Abort situation during maintain:
• The battery is severely sulfated or has a weak cell and will not hold a charge.
• There is a large draw on the battery and the charger has to supply its maximum maintain
current for a 12 hour period to keep the battery at full charge.
• Recondition mode is unsuccessful.
BATTERY DISCONNECTED (No LED lit) – After charging has begun, the charger has lost
its connection to the battery.
OFF (No LED lit) – During the charge process or Recondition process, press the button once to
stop the charge or recondition. The display will show OFF and then SELECT CHARGE MODE.
NOTE: To change the language on the display, press and hold the Language button
for 5 seconds. (EN→ DE→ FR).
GERMAN (DE)
LADEMODUS AUSWAEHLEN
12V - STANDARD LADUNG - EINMAL DRUECKEN FUR 24V - ZWEIMAL FUR
REKONDITIONIERUNG MODUS
12V - KLEMMEN ANSCHLIESSEN - EINMAL DRÜCKEN FUR 24V - ZWEIMAL FUR
REKONDITIONIERUNG MODUS
12V - REKONDITIONIERUNG MODUS - EINMAL DRÜCKEN FUR 24V - ZWEIMAL FUR
STANDARD MODUS
24V - STANDARD LADUNG - EINMAL DRÜCKEN FUR 12V - ZWEIMAL FUR
REKONDITIONIERUNG MODUS
24V - KLEMMEN ANSCHLIESSEN - EINMAL DRÜCKEN FUR 12V - ZWEIMAL FUR
REKONDITIONIERUNG MODUS
24V - REKONDITIONIERUNG MODUS - EINMAL DRÜCKEN FUR 12V - ZWEIMAL FUR
STANDARD MODUS
REKONDITIONIERUNG - RESTZEIT XXX MINUTES
• •
10