Table of Contents
Advertisement
3. Secure the back side of the slider rail unit to the back post, use a level to make sure the slider
rail unit is level.
4. Tighten the slider brackets screws to the slider body and stiffener.
5. Repeat steps 1-4 for the opposite side of the rack with the second slider rail unit.
6. Clearance/Level Testing
• Extend the sliders arms all the way out through the front of the rack
• Use the jig by placing it on the 2 extended slider arms
a. Check right to left leveling using a level, adjust sliders front brackets as needed.
b. Run the jig between the 2 sliders from the front of the rack to the back to check for clearance.
c. When the jig is in the back, check the level again. Adjust back screws if needed.
7. Installing additional set of sliders (if applicable)
• Install the ROME positioning ruler, where the lower
end should be on top of the installed slider
• Repeat steps 2 to 6
Note: There is a 12 inch clearance from the bottom
of the rack.
Page 8
Jig in Front of Rack
Hardware
Installation Manual
Jig in Back of Rack
Advertisement
Table of Contents
