Charging The Battery - Yamaha AQUA CRUISE User Manual

Charging the battery

To charge the battery follow these instructions.
1. Always ensure that the Master Switch is OFF
(See Fig.6).
2. Always ensure that the AQUA CRUISE is out of the
water, dry and placed in a dry area.
3. Use a small coin to unscrew the Screw Cap
counter-clockwise. (See Fig.7).
Screw Cap
11
OFF
Fig.6
Fig.7
4. Pull out the Screw Cap slightly to a maximum of 12mm
ONLY. DO NOT PULL OUT THE SCREW CAP AND
STEM COMPLETELY. (See Fig. 8)
5. Press on Screw Cap to release locking mechanism of
Battery Door. (See Fig. 9)
6. Pull out Battery Door part to access battery.
12mm
Fig.8
7. Allow two minutes for any gasses to dissipate.
8. Take out the battery from the Battery Compartment
and place on a level surface.
9. Connect the battery to the Charger (See Fig.10).
10. Plug Charger into electrical socket/plug, and turn on
the supply.
11. Charging will take 6-8 hours for a fully discharged
battery. When the battery is charging the LED on the
Charger turns RED. When the battery is charged the
LED turns GREEN.
12
Battery
Door
Fig.9
Fig.10