Recovery From Error Modes; Service / Maintenance; Preventive Maintenance - MANDREL welder EErgo Instruction Manual

• The exact melting- and cooling times are depending on the type of mandrel as
well as the environmental conditions. We suggest to practice the welding pro-
cess and to do testing in advance.

2.4 Recovery from error modes

• If both of the LEDs are blinking (green or red), alternating or simultaneously,
the EErgo has entered one of the error modes.
• It is possible to try to recover an error mode by pressing one of the keys, ac-
cording to desired working temperatur, PP or Nylon.
• In case of repeatedly entering an error mode, the number of the recovery at-
tempts is limited to four.
• However, in case of an error mode, a user is advised to immediately contact the
service, since operating in an error mode can lead to overheating of the unit.

3.0 SERVICE / MAINTENANCE

3.1 Preventive maintenance

Please clean hot paddle after every welding process and replace hot pad-
dle, if permanent polluted surface and/or antisticking layer is released/
weared out.
14