Starting; Description Of Functioning Sbc Models; Switching Device; Turn Off The Device - PROMIENNIKI GAZOWE SBC 2 Operating And Maintenance Manual

CERAMIC RADIANT HEATERS

Starting

Description of functioning SBC models

Devices are automatically equipped in flame control sensor, which is in separate box and
electric valve feeded by a duct with voltage 230V/50Hz.
 After switch on the heater, it starts sparking and the electric valve is opening in the
same time
 The sensor monitoring the ignition and when heater is ignited, sparking is switch off
 In case when the flame will be detected, after 20 sec the radiator will be locked.
Restart the heater by cut off electric power for min 20 sec, and you have to repeat
start-up.
 To switch off the heater, you have to cut off the device from electric power by a
switch located in controller

Switching device:

1. Open gas valves gas,
2. Switch on entire power button panel
3. Set thermostat device to the desired temperature
4. Press the power button for selected radiators.

Turn off the device

1. Set room thermostat to the minimum,
2. Turn off power for individual radiators
3. Turn off main power switch
4. Close the gas valve from the device.
If all devices must be switched off for a long time, in addition, we recommend disconnecting
the power supply from the control panel and close the main gas valve
EN.SBC_v2_1 Feb 2019
Promienniki Gazowe .
Sp. z o.o
17