Advertisement
Figure 3" Remove Factory Airbox Cover
PREPARATION FOR INSTALLATION
1. (Optional) This is a good time to clean your MAF sensor using a specially formulated sensor
cleaner you can buy at any local Auto Parts store.
INSTALLATION
Mount the MAXX-FLO™ to the factory intake manifold at the factory grommet locations.
1. Lubricate the 3 mounting legs on the bottom of the MAXX-FLO™ housing with foaming window
cleaner or a very light film of lubricating grease. Push the housing with mounting legs into the
same (3) rubber grommets in the intake manifold which located the factory air box base. The
MAXX-FLO® will snap into place.
2. Install the silicone elbow and clamps supplied with your kit onto the air tube on the MAXX-FLO®.
Do not tighten.
3. Install the MAF housing between the factory air inlet hose and silicone elbow. Verify it is installed
in the proper air flow position. The sensor only works in on direction | air flowing from the MAXX-
FLO™ towards the turbo.
4. Align everything in the air tract to eliminate any stresses or twists. Trimming of the silicone elbow
may be required on some applications to get the best alignment. If necessary you can trim the
silicone elbow using masking tape as a guide and a hack saw to cut it. If you cut the elbow
thoroughly clean the inside to remove any leftover particles and dirt. Once you are satisfied with
the alignment, tighten the (2) hose clamps.
011-25-2015
Figure 4: Removal of Fresh Air Hose
www.m7speed.com
Page 3 of 4
PO Box 3785
Mooresville, NC 28117
888-438-5767
Advertisement
