Advertisement
5. Plug in the MAF sensor electrical connector.
6. Install the supplied air filter. Follow the direction on the filter bag. It is very important to thoroughly
clean the inside of the filter cuff of all oil. It must be absolutely oil free before it is attached to the
adapter tube.
7. Safety check | Check that all hardware & clamps are tight, all electrical connections are plugged in
and all hoses and necessary parts are installed properly.
8. Reconnect battery.
9. OPTIONAL: Remove the blocker plate from your scoop if it is still installed. This allows fresh air to
enter the engine compartment flushing away heat and supplying air to the intake.
NOTE: The M7 Vortex 2 Scoop is designed to work with this intake system and provides maximum
fresh air flow to your engine.
011-25-2015
Pleated Filter Shown
www.m7speed.com
Page 4 of 4
PO Box 3785
Mooresville, NC 28117
888-438-5767
Advertisement
