Advertisement
Quick Links
Foam Filter Shown
M7 Speed engineers and manufactures the highest quality and best fitting Mini Cooper accessories
and performance parts available anywhere on Planet Earth! Please inspect your parts when you
receive them to verify everything is included and no damage has happened during shipment. Read
these instructions completely BEFORE attempting to install this product. If you are not confident you
can do the work described or do not have the tools or skills necessary please contact a local M7
dealer (listed on or website www.m7speed.com) or a local automotive accessory installation center to
perform this work. We acknowledge not everything is perfect but we work very hard every day to
improve our products and make installations easier. If you have any comments please contact M7
Customer Service directly at 704-663-0094. We encourage and welcome all criticism. Thank you.
FOR YOUR SAFETY INSTALL THIS PRODUCT ONLY WHEN THE ENGINE IS COLD.
THIS WILL PROTECT YOU FROM INJURY AND DAMAGE TO YOUR ENGINE & COMPONENTS.
Tools & Supplies Required:
•
T-25 Torx
•
T-27 Torx
•
1/8" hex wrench
Estimated Install Time (Actual time may vary):
30-60 minutes
Parts Checklist
1 MAXX-FLO® Airbox
2 #44 (3 ¼") Hose Clamps
011-25-2015
M7 Speed MAXX-FLO™ Air Intake System
56-312101 - Black Aluminum Housing
56-312201 - Brushed Stainless Housing
www.m7speed.com
Page 1 of 4
Pleated Filter Shown
•
Flathead Screwdriver
•
Phillips Screwdriver
•
Foamy window cleaner or similar
product
•
MAF sensor cleaner (optional)
1 Filter – Pre-oiled Pleated Cotton or 2 Stage Foam
1 Silicone Elbow
PO Box 3785
Mooresville, NC 28117
888-438-5767
RED | BLUE | BLACK
Advertisement
Summary of Contents for M7 SPEED MAXX-FLO 56-312101
- Page 1 Pleated Filter Shown Foam Filter Shown M7 Speed engineers and manufactures the highest quality and best fitting Mini Cooper accessories and performance parts available anywhere on Planet Earth! Please inspect your parts when you receive them to verify everything is included and no damage has happened during shipment. Read these instructions completely BEFORE attempting to install this product.
- Page 2 PO Box 3785 Mooresville, NC 28117 888-438-5767 REMOVAL OF THE FACTORY AIR BOX 1. Disconnect the battery. 2. Disconnect MAF sensor connection; (Figure #1) a. The MAF plug on the intake hose. Push down on the small tab on the harness side and gently pull the plug out.
- Page 3 PO Box 3785 Mooresville, NC 28117 888-438-5767 Figure 3” Remove Factory Airbox Cover Figure 4: Removal of Fresh Air Hose PREPARATION FOR INSTALLATION 1. (Optional) This is a good time to clean your MAF sensor using a specially formulated sensor cleaner you can buy at any local Auto Parts store.
- Page 4 PO Box 3785 Mooresville, NC 28117 888-438-5767 5. Plug in the MAF sensor electrical connector. 6. Install the supplied air filter. Follow the direction on the filter bag. It is very important to thoroughly clean the inside of the filter cuff of all oil. It must be absolutely oil free before it is attached to the adapter tube.