Advertisement
Step 4: Installing the Jumping Mat
Now open up the spring boxes. There will be 8 short springs, it will be for the corners.
Please make sure no one is standing on the opposite side of the trampoline while springs are being
installed to avoid injury. Due to a lot of tension, springs can and will fly if not properly hooked and
handled. Hold spring and spring tool with each hand at all times during the spring installation process.
Wear protective eye goggles to prevent any injury
It is very important that you do not go around the trampoline and put all the springs on from left to right. This
trampoline has over 100 springs and there will be lots of pressure.
Very important to insert the springs according to the numerical order of the diagram. Insert 2 springs, skip
about 3 slots. Go to the opposite side of the trampoline, insert 2 springs, then skip 3 slots. Go to the
opposite side of the trampoline, insert 2 springs, then skip 3 slots. Repeat this process until you are
finished with the both long sides of the trampoline. Once you are done repeat this process for the short
side of the trampoline. Then install the corner springs.
This an industrial made frame therefore it is very tight and you may have difficulty putting the springs
together with one person. It will require 2 to 3 adults to put together. If you are unable to put the springs
on with the spring tool because it is too much tension to pull or too far apart, you can use a heavy duty
ratchet tie down strap
to temporary hold the frame in place.
Advertisement
