Safety Markings; Personnel Requirements; 2.7.1 Qualifications - Vetter SmartTarget ST-2A-GL-01 Operating Instructions Manual

2.6

Safety markings

Nameplate
The nameplate (respectively the stated article number) identifies the version of the SmartTarget on delivery. Do not start the
SmartTarget without a nameplate. The nameplate is located on the side of the fork back.
VETTER Industrie GmbH
Carl-Benz-Strasse 45
D-57299 Burbach
ST-2A-GL-01
1
Laser beam safety label
The line laser target function uses laser beams up to class 1M. There is a risk of dazzling.
There is also a risk of damage to the eyes if you look deliberately into the beam path for a longer period of time.
▪ Do not look into the beam or observe the beam directly with optical instruments (e.g. magnifier or binoculars).
▪ If the laser module lens is damaged, stop using the SmartTarget immediately as there is a risk of increased laser radiation.
2.7

Personnel requirements

2.7.1 Qualifications
V.01/2021
5 kg/Stk./pc.
2
3
Fig. Laser beam warning sign
WARNING!
Risk of injuries from inadequately qualified personnel!
If unqualified personnel works with the system or is present in the danger zone of the system,
this causes dangers that can result in severe injuries and considerable material damage.
▪ All tasks should only be carried out by suitably qualified personnel.
▪ Keep unqualified personnel away from the danger zones.
1 Article No.
2 Deadweight (pc)
3 Laser specification
SmartTarget 35