Page 1
SN / SM SERIES Spot PLEASE READ THIS MANUAL BEFORE USING THE PRODUCT HUSSMANN – CORPORATION Hussmann Monterrey, Mexico Carretera Mexico-Laredo KM. 1009 Cienega de Flores, Nuevo Leon 65550 MEXICO Phone: (52) 81-8318-6400 Fax: (52) 81-8318-6496 Low Temperature Merchandisers SN-075...
Table of Contents SHIPPING DAMAGE General Apparent Loss or Damage Concealed Loss or Damage Location PREPARATION OF CABINET FOR OPERATION Removing Cabinet from Skid Door installation (SN Models) Operation Load Limit REFRIGERATION SYSTEM Description Defrosting Instructions START UP / OPERATION Electrical Supply Temperature Control High Pressure Switch...
General All equipment should be thoroughly examined for shipping damage before and during unloading. This equipment has been carefully inspected at our factory and the carrier has assumed responsibility for safe arrival. If damaged, either apparent or concealed, claim must be made to the carrier.
PREPARATION OF CABINET FOR OPERATION Removing Cabinet From Skid Move the Spot Merchandiser as close as possible to its permanent location and remove hold-down brackets at the front and rear of the cabinet. Check refrigeration lines to see that they are “free”...
Description All Merchandisers are equipped with a hermetic compressor. The refrigeration system works with 404a refrigerant. It is really important not to change or mix refrigerants during service. If another refrigerant than the specified is used, the performance of the case will be affected.
Electrical Supply Wiring of the unit is complete when it is shipped from the factory. The unit is supplied with three electrical cord which extends from a side of the unit. Plug the unit into correct grounded outlet. recommended that a separate circuit be run for each cabinet to prevent the possibility of another appliance blowing a fuse, causing subsequent loss of...
Need help?
Do you have a question about the SM-110 and is the answer not in the manual?
Questions and answers