Larscom ACST-1500B Series Installation And Operation Manual page 201

ACST-0351-005
June 1996
5. Specify the slaves to be polled as follows:
6. Enable or disable alarm dialout or changes of polling status as fol-
7. Press the
8. Verify the polling configuration as described under Viewing the
a. Select .
POLL
b. Select to specify a slave to be polled (or
ENABLE
a slave which is no longer to be polled).
c. Enter the two-digit node address (
the key, followed by the
Enter
d. Repeat substeps 5b and 5c for additional slaves as desired.
lows:
a. Press the key to return to the
Esc
b. Select if a change of the slave's polling status is to cause
ENABLE
an alarm dialout by the master (or
change of polling status is no longer desired).
c. Enter the two-digit node address (
the key, followed by the
Enter
d. Repeat substeps 6b and 6c for additional slaves as desired.
key repeatedly to return to the Main Menu Line.
Esc
Chain Port Polling Configuration later in this chapter.
Note 1: Dialout for polling status alarms occurs only
POLL
if the and
DIAL
is enabled but
DIAL
terminal connected to the master's Craft Port, but no
dialout will occur on the master's Supervisory Port.
Note 2: For modem dialout to operate properly, the
master Access-T must have a legal dialstring defined,
and the Start and Stop times must be different.
Note 3: The master's node address need not be enabled
for polling.
Using Access-T as a Master
to ) of the slave. Then press
01 30
key.
Esc
menu and select
POLL/DIAL
DISABLE
to ) of the slave. Then press
01
30
key.
Esc
features are both enabled. If polling
is disabled, alerts will occur at the
Chapter 8
to specify
DISABLE
.
DIAL
if a dialout on the
8-5