Cisco MGX 8850 System Installation And Configuration Manual page 4

Cisco systems plastic motherboard insulator installation and configuration guide

Hide thumbs Also See for MGX 8850 System:

Press the center of the plastic cover to snap the tabs into the card cage perforations as shown in the

Step 6

illustration below. Keep the plastic cover between your fingers and the motherboard.

Step 7

Continue to press the plastic cover starting from the center then moving to each outside edge to snap

the remaining tabs. You should be able to hear an audible click as these tabs are snapped into place.

Step 8

Replace the plastic grill removed in Step 1 and secure with the two screws using a flat blade screw

driver.

This completes the installation of the plastic insulating cover.

Installing Plastic Motherboard Insulator in an MGX 8850 System

Underside of chassis

78-10389-01