Yamaha Wolverine RMAX Owner's Manual page 40

Push the "MODE" button to switch between
the clock "CLOCK", the hour meter "HOUR",
the voltage display "VOLT", and the coolant
temperature display " " in the following or-
der:
CLOCK → HOUR → VOLT →
5
To set the clock
1. Set the display to the clock.
2. Push both the "SELECT" button and
"RESET" button until the hour digits start
flashing.
3. Use the "RESET" button to set the hours.
4. Push the "SELECT" button, and the min-
ute digits will start flashing.
5. Use the "RESET" button to set the min-
utes.
6. Push the "SELECT" button, and then re-
lease it to start the clock.
Voltage display
→ CLOCK
1
1. Voltage display
This display shows the battery voltage. If the
battery voltage is less than 10 volts, "Lo" is
displayed, and if the voltage is above 18 volts,
"Hi" is displayed.
ECB03570
NOTICE
If the voltage display indicates "Lo" or
"Hi", there may be trouble with the battery
charging circuit or the battery may be
faulty. If this occurs, have a Yamaha dealer
check or repair the vehicle.
5-9