Change Click Volume During Parameter Modify Recording; Clock Move - Yamaha RY30 Authorized Product Manual

Change Click Volume During
Parameter Modify
Recording
l Clock Move
30
l BALANCE: Rolling the wheel upward increases the level of WAVE 1 while
decreasing the level of WAVE 2, and rolling the wheel down has the oppo-
site effect. See "Voice Editing Fundamentals" beginning on page 41 for a
discussion of voice waves.
6. You can press an instrument pad, use the [INC] and [DEC] keys, or use the
[DATA] control to select a different instrument (you can also select an
entirely different pad bank if necessary), and use the wheel parameter
selector to select a different parameter at any time in the parameter record
mode.
NOTE: The UTILITY mode WHEEL RANGE job described on page 76 allows you
to independently set the wheel range for the pitch, decay, pan, filter, and bal-
ance parameters, so you can select the best wheel "sensitivity" for your own
requirements.
If you press the [PAGE] key during parameter a display like the following will
appear.
Use the [INC] and [DEC] keys, the numeric keys, or the [DATA] slider to
change the click (metronome) volume as required. The click volume parameter
goes from 00 (no click sound) to 63 (maximum click volume).
Press the [EXIT] key to return to the normal parameter record display.
Subtle shifts in note timing are what give vitality and warmth to "live" sound.
The clock move mode lets you modify note timing to suit your own requirements
by operating the RY30 control wheel while monitoring the results in real time.
1 . Select a pattern that has already been recorded, then press the [REC] key
to engage the record-ready mode.
2. Press the [INC] key three times to select the clock move mode.