Table of Contents
Advertisement
UTILITY MODE
Notes: "INTERNAL" is the normal setting when the
RY30 is being used alone. If you are using the
RY30 with an external sequencer, MIDI computer,
or other MIDI device, and you want the RY30 to
be synchronized to the external device, set this
function to "MIDI." In the latter case, the exter-
nal device must be connected to the RY30 MIDI
IN connector, and must be transmitting an appro-
priate MIDI clock signal.
JOB 02: PAD VELOCITY CURVE
Summary: Selects one of three different velocity
curves for the RY30 instrument pads.
Settings: Curve type: 0 (NORMAL), 1 (EASY), 2
(WIDE)
Procedure: Use the [INC] and [DEC] keys or
[DATA] slider to select the desired velocity
curve.
Notes: This function lets you select the velocity curve
that best suits your playing style. Try each one
out to find the one you like best.
JOB 03: FIXED VELOCITY
Summary: Determines the fixed velocity value
(loudness) of the RY30 voices when pad sensi-
tivity is turned off (i.e. when the [SENSE] key
indicator is out).
Settings: Velocity: 001 . . . 127
Procedure: Use the [INC] and [DEC] keys, the
[DATA] slider, or the numeric keys to set the
desired velocity value.
76
Notes: While the "LEVEL" function described on
page 81 determines the overall level of each voice,
this function determines the voice levels — and
therefore the balance between voices — when pad
velocity sensitivity is turned off (i.e. when the
[SENSE] key indicator is not lit).
JOB 04: WHEEL RANGE
Summary: Independently sets the range of the RY30
control wheel for the pitch, decay, pan, filter, and
balance parameters.
Settings: Parameter: Pitch, Decay, Pan, Filter,
Balance
Range: xl, x2, x4
Procedure: Use the
cursor to the desired parameter. Use the [INC]
and [DEC] keys or the [DATA] slider to set as
required.
The parameters can also be selected via the
numeric keys (refer to the labels above the [8],
[9], [4], [5], and [6] keys).
Notes: This function determines the degree of varia-
tion produced by the control wheel when using the
parameter modify record option described on page
28. The "x1" setting produces the minimum vari-
ation for a given amount of wheel movement. The
"x2" approximately doubles the amount of varia-
tion produced by the same amount of wheel
movement, and the "x4" setting doubles the
amount of variation again.
JOB 05: LOAD PRESET VOICES
Summary: Re-loads the RY3O's preset voices into
the internal voice memory (I00 . . . I95).
Settings: None
and
keys to move the
Advertisement
Chapters
Table of Contents
