SENSORWORX SWX-851 Series Installation & Operation Instructions page 6

CONFIGURATION SETTINGS
FUNCTION #5: RELAY ENABLE/DISABLE
If the wall switch load controller is being used as a remote switch for another load controller and not controlling a lighting load of its own, the relay can be disabled. To disable, follow the
below steps.
SETTING # DESCRIPTION
2 Relay enabled (default)
3 Relay disabled (i.e. always closed)
DISABLING THE RELAY
1 Enter programming mode by pressing and holding the button for at least 6 seconds until the LED begins flashing blue only, then release.
2 Press and release the unit's pushbutton 5 times, wait 2 seconds, then press the button 3 times to disable the relay (or 2 times to enable).
3 To Save the setting and Exit programming mode, press and holding the button until the LED changes to blue, then release. The LED will then blink white twice as confirmation of
success.
Note: To Exit without saving during any step, release button and wait until the unit double flashes blue.
FUNCTION #7: LED BEHAVIOUR
When the load controller has switched the lights off, the unit's LED will be solid blue as a locator. To disable this locator LED functionality, follow the below steps.
SETTING # DESCRIPTION
Locator LED enabled (default)
2
3 Locator LED disabled
CHANGING THE LED BEHAVIOUR
1 Enter programming mode by pressing and holding the button for at least 6 seconds until the LED begins flashing blue only, then release.
2 Press and release the unit's pushbutton 7 times, wait 2 seconds, then press the button 3 times to disable location functionality (or 2 times to enable).
3 To Execute the command and Exit programming mode, press and holding the button until the LED changes to blue, then release. The LED will then blink white twice as confirmation of
success.
Note: To Exit without saving during any step, release button and wait until the unit double flashes blue.
FUNCTION #8: RESTORE FACTORY DEFAULTS
To return a wall switch controller to its original factory default settings, follow the below steps:
1 Enter programming mode by pressing and holding the button for at least 6 seconds until the LED begins flashing blue only, then release.
2 Press and release the unit's pushbutton 8 times, wait 2 seconds, then press the button 3 times.
3 To Execute the command and Exit programming mode, press and holding the button until the LED changes to blue, then release. The LED will then blink white twice as confirmation of
success.
Note: To Exit without saving during any step, release button and wait until the unit double flashes blue.
(CONT.)