Cisco LightStream 2020 Installation Manual page 26

Basic LS2020 Configuration Tasks
Step 5
2-26 LightStream 2020 Installation Guide
If the network processor is attached to an Ethernet LAN, you will be asked to provide
the IP address and IP subnet mask of the network processor's on-board Ethernet LAN
interface.
Is the network processor attached to an Ethernet LAN (Y/N)? [N} Y
Configure the IP address for the network processor's Ethernet LAN interface.
Network Processor Ethernet IP Address [a.b.c.d]: 197.112.23.11
Configure the IP subnet mask for the network processor's Ethernet LAN interface.
Network Processor Ethernet IP Mask [a.b.c.d]: 255.255.255.0
Is there an IP router on the attached Ethernet LAN (Y/Y)? [N] Y
Configure the Default IP router on the network processor's Ethernet LAN interface.
Network Processor Ethernet Default IP Router [a.b.c.d]: 197.112.23.1
CHASSIS INFORMATION
Host Name:
Chassis Primary (Active) IP Address:
Chassis Secondary IP Address:
Chassis Subnet Mask:
Network Processor Ethernet IP Address:
Network Processor Ethernet IP Mask:
Network Processor Default IP Router:
Chassis configuration contains 1 network processor.
Network processor's on-board Ethernet LAN interface is attached to an external
Ethernet LAN.
Is the chassis and network processor information correct? (Y/N)? [Y] Y
If you confirm that the configuration data you have entered in this step is correct by
responding to this query, the script continues with the trunk port configuration query
Y
below.
On the other hand, if you wish to change any configuration data, answer "
and network processor information query and repeat this step in its entirety. You will be
prompted by the configuration script to re-enter all the applicable network management
information for your LS2020 switch.
Configure trunk port information (Y/N)? [N] N
Creating minimum configuration database...done.
Similarly, if you respond
N
that it is creating a minimum configuration database and that you have completed the basic
configuration procedure.
If you respond " " to the trunk port configuration query, proceed with Step 6.
Y
If your LS2020 switch contains a redundant network processor, continue with the
configuration script, as follows:
Does the chassis contain redundant network processors (Y/N)? [N] Y
LightStream1
192.1.1.11
<none>
255.255.255.0
197.112.23.11
255.255.255.0
197.110.175.2
to the above trunk port configuration query, the system reports
" at the chassis
N