Table of Contents
Advertisement
Caution
for this particular LS2020 node, effectively deleting the files.
If configuration files are present and you choose not to overwrite them, the setsnmpconfig script
cannot continue. Instead, the script exits and returns you to the command line.
If configuration files are not present, or if they are present and you choose to overwrite them, a script
prompts you to enter network configuration information, as outlined in the following section,
"Entering Configuration Data."
Entering Configuration Data
In this procedure, a script prompts you to enter basis LS2020 configuration information. In
performing this procedure, it is assumed that you have already initiated the boot sequence, as
previously described in the section "Connecting the Terminal to the NP."
Note
displayed instead of the system output shown in Step 1 below. In this case, refer to Appendix B
Software Reinstallation.
Step 1
If you answer y (yes) to this query, the system overwrites the existing configuration files
If a problem occurs with the LS2020 hard disk or the platform software, an error message is
Observe the system's boot display:
**** LynxOS is down ****
***booting: drive:0, partition:0, kernel:"lynx.os", flags:0x4308
Resetting SCSI bus
Kernel linked for 0xea010000
LOAD AT 0x10000
471040+40960+136260[61824+50608]
TOTAL SIZE: 745080 at 0x1001c
START AT 0x10020
NP memory size: 32 MB
ILACC: EEPROM enet addr:8:0:8:0:14:25, Silicon Rev:0x5, IB:0xea146620
virtual console: IB: 0xea139d20
NCR 53C710: Chip Revision: 0x2, IB: 0xec13d000
LynxOS/68040-MVME167 Version 2.2.1
Copyright 1992 Lynx Real-Time Systems Inc.
All rights reserved.
LynxOS release 2.2.1, level 1: NP-LynxOS #57: compiled Mar 05 1996 12:38:19
LynxOS Startup: ma
fsck /dev/sd0a
(all sizes and block numbers in decimal)
(file system creation time is Tue Mar 5 20:07:12 1996)
checking used files
recovering orphaned files
making free block list
making free inode list
43967 free blocks 3343 free inodes
fsck /dev/sd0b
(all sizes and block numbers in decimal)
(file system creation time is Tue Mar 5 20:07:33 1996)
checking used files
recovering orphaned files
Basic LS2020 Configuration Tasks
Hardware Installation 2-23
Advertisement
Table of Contents
