Download
Share
Print this page
Merra CFN-1013 Instruction Manual
  1. Manuals
  2. Brands
  3. Merra Manuals
  4. Fan
  5. CFN-1013
  6. Instruction manual

Merra CFN-1013 Instruction Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
Model:CFN-1013

Advertisement

loading
Need help?

Need help?

Do you have a question about the CFN-1013 and is the answer not in the manual?

Questions and answers

Related Manuals for Merra CFN-1013

Summary of Contents for Merra CFN-1013

  • Page 1 Model:CFN-1013...
  • Page 3 STOP Unpack your fan and check the contents. You should have the following items: Fan blades (5) Ceiling mounting bracket Canopy n n n n n n n Canopy cover Ball/downrod assembly Coupling cover g. Fan housing h. Fan motor assembly L i ight plate led light kit glass shade...
  • Page 5 5. ATTACHING THE GSN BLADES Screw Step 1. Attach the blade to the flywheel using the screws with spring washer in the bag as shown in figure 5. Screw Star screw into flywheel.Repeat for the two remaining screws. Step 2. Repeat for the remaining blades. Step 3.

  • Page 6: Hanging The Fan

    7.HANGING THE FAN Fig 8 Downrod Canopy Canopy cover bracket as shown in fig 8. Coupling cover Set screws Hitch pin Retaining clip through the ball/downrod.(Fig 9) Fig 9 the motor housing (fig.9).Carefully insert the position, as noted in the circle inset of Fig.9. fan motor firmly.(Fig.9) bracket socket.(Fig.10) Fig 10...

  • Page 7: Electric Connections

    8.ELECTRIC CONNECTIONS WARNING: To avoid possible electrical shock, be sure you have turned off the power at the main circuit panel. Follow the steps below to connect the fan to your household Receiver wiring. Use the wire connecting nuts suppled with your fan.
  • Page 8 9. FINISHING THE INSTRUCTION Canopy cover Fig 13 Fig 13 10. INSTALLING THE LED LIGHT KIT AND LAMP SHADE NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box. Step 1. Loosen the three screws on the round plate and "remove"...
  • Page 9 11. Operation for remote KINDLY REMINDERS: Learning code maching mode is useed between emitter and receiver,Turn "ON" the supply power within 30 seconds and press the emitter's "LI" and "Hi"button for 3 seconds, it can load normally after hearing the "BEE" which means learning successfully and it can works normally.(PS:Learing mode is not acepted after turn "ON"...

  • Page 10: Troubleshooting

    12.TROUBLESHOOTING...