RUSTGO 139 Instruction And Safety Manual page 3

General OSHA Standard Part 1910
Subpart D 1910.29 Manually Propelled Mobile Ladder Stands and
Scaffolds (Towers)
(a) General requirements Section(e) Mobile work platforms
When in use in the field on a job site refer to 1926.452(w), then
(NON-MANDATORY) APPENDIX A TO SUBPART L – SCAFFOLD SPECIFICATIONS
1926.450(W) MOBILE SCAFFOLDS. Stability test as described in the ANSI A92 series documents, as appropriate for the type
of scaffold, can be used to establish stability for the purpose of Sec. 1926.452(w)(6).
RUSTGO mobile work platforms may be used as a guardrail system for fall protection. RUSTGO mobile work platforms
meet the OSHA requirements for a guardrail system under SUBPART M 1926.502 FALL PROTECTION SYSTEMS CRITERIA AND
PRACTICES (a) General and (b) Guardrail systems. Any additional requirements such as tying off, screens, mesh, etc. shall be the
users responsibility.
NOTE: RUSTGO mobile work platforms are not designed to withstand the forces imposed by the Personal fall arrest systems or
Positioning device systems as in OSHA Section 1926.502(d & e) Subpart M.
IMPORTANT: A COPY OF THE ANSI/SIA A92.3-1990 MANUAL OF RESPONSIBILITIES IS INCLUDED WITH THIS INSTRUCTION
MANUAL. IT CONTAINS IMPORTANT OPERATING INFORMATION FOR THIS RUSTGO PRODUCT. READ IT BEFORE OPERATING THIS
RUSTGO WORK PLATFORM.
When properly used in accordance with the listed OSHA requirements and ANSI standard RUSTGO manually propelled work
platforms meet said standards.
MANUALLY PROPELLED WORK PLATFORMS
RUSTGO CO., 48926 State Hwy. 12, Spencer, NE 68777 USA
CLASSIFICATIONS OF RUSTGO MOBILE WORK PLATFORMS:
RUSTGO work platforms are categorized by the following
ANSI/SIA A92.3-1990 Manually Propelled Elevating Aerial Platforms
RUSTGO work platforms are categorized by the following
MANUAL 2010 March
Are manufactured by
2
ANSI
Standard:
OSHA
Standard: