Table of Contents
Advertisement
09.
Maintenance
S-Energy Co., Ltd. to ensure optimal performance of the module, it is recommended to maintain.
1)
To ensure the electrical and mechanical safety of module, check the electrical and physical connection on a regular basis.
※ Modules and structural loosening bolts, check that there are indisposition grounded and the ground wire corrosion.
※ Please confirm that no shading occurs due to the surrounding vegetation and buildings in front of the module.
※ Junction box and connectors, check that there are no loose and damaged the fixed site.
2)
To maintain a stable generation performance please check the regularly around the module front and rear.
※ Please confirm that there are no front glass breakage.
※ Please check back Backsheet there is burnout.
※ Make sure there are no heat problems during generate of the module.
※ Please confirm that no modification coating module wiring section and burnout.
CAUTION
Installation and maintenance of the photovoltaic modules must be carried out only by qualified personnel held.
※
Wear safety equipment during maintenance.
※
Maintenance of the photovoltaic modules other components, please refer to the vendor Maintenance Manual.
※
10.
Cleaning Instructions
The front glass of the modules produced in S-Energy Co., Ltd. is using the general low iron glass and the
ARC glass to minimize with light reflection. Cleaning time is taking into account the thermal shock and
power generation, please proceed early in the morning and cloudy weather.
Cleaning method and procedure
Step 1: Off bets
Such as dry leaves and debris on the module surface will have to pay it off with a dry cloth or dust tremble.
If there is debris on the module surface, cleaning of these steps will be omitted because it is completed.
Step 2: Wipe
Dirt, bird secretions, twigs, leaves, etc., if solid foreign objects attached to the module, please wipe gently with a
soft cloth that do not cause injury to the module.
Step 3: Rinse bet
Bird secretions, unable to shake off the dust cause of external humidity or plant essences such as colored debris
on the module surface, should be removed by rinse bet method.
For the colored debris remove give neutral water sprayed on the affected area and wipe gently with a soft cloth,
makes regular cleaning necessary.
CAUTION
S-Energy modules are designed to withstand pressure 30lbs/ft²(UL 1703) and 5,400Pa(IEC 61215).
※
If you decide to clean the snow in order to ensure the long-term growth and performance of the power
generation module, the module's surface, do not remove the ice. Scratch the surface can be generated.
There is a danger of electric shock, broken glass and broken wires, exposed wires, do not wash.
※
Do not use the grinding dust, polish, sodium, benzene, alkali, and other chemical substances.
※
09
S-Energy PV Module Installation Manual
Advertisement
Table of Contents
