List Of Parts And Tools - Cisco 7000 Installation Instructions Manual

List of Parts and Tools

This section lists the tools you will need to complete this installation and the parts that are shipped
as part of the rack-mount kit. Ensure that you have all the tools and parts required so that you can
complete the installation without interruption.
Tools Required
You will need the following tools to install the mounting hardware and chassis in the rack:
•
Number 2 Phillips screwdriver
•
One 7/16-inch, open-end (or adjustable) wrench if you will remove the chassis feet
•
Tape measure or level (both optional)
•
Ohmmeter if your installation requires the chassis to be electrically isolated from the rack
You also need the following tools to replace the power supplies after mounting the chassis:
•
A number 2 Phillips or 1/4-inch, flat-blade screwdriver for the captive screw. (Because of
ongoing product improvements, some power supplies use slotted screws, and others use Phillips
screws.)
•
If cables from other equipment fall in front of the power supply bays, you will need cable ties to
temporarily anchor the cables out of the way while you install the power supplies.
Before beginning the power supply installation, check the captive installation screws on all power
supplies to determine which tools you will need.
Parts List
Table 1 lists the parts that are included in the rack-mount kit. To verify that you received all the parts
listed, refer to Table 1 and to Figure 2 on page 4. If any are missing, contact a service representative
for assistance. (Refer to the section "Cisco Information Online" at the end of this document.)
Table 1
Quantity
2
2
4
10
Note
that follow.
Rack-Mount Kit Parts Checklist
Part Description
Mounting brackets (left and right are identical), each with an attached spanner bar
Chassis ears with captive grommets (left and right ears are identical)
M4 x 10-mm LG Phillips flat-head screws
10-32 x 5/8'' LG Phillips pan-head screws with integral square cone washers
As you perform the installation, refer to Figure 2, on page 4, and to the detailed illustrations
Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions
Prerequisites
Received
15