Starting The Device - ZLG MiniPCIeCAN-2E-U User Manual

MiniPCIeCAN-2E-U
MiniPCIe Interface CAN Card User Manual
User Manual
Figure 4.11 Wiring diagram

4.2.2 Starting the Device

Run the CANTest software and select the device type. See 4.1.1 Summary. Configure
the device, as shown in Figure 4.12 and Figure 4.13. Pay attention to the selection of CAN
channels. The device index number is a code that identifies the device. The same device
index number should be selected for different CAN interfaces of the same device.
Different device index numbers are selected for different devices select . Generally, device
index numbers start from 0. The number of CAN channels is used to distinguish different
CAN channels under the same device index number. This device has two CAN channels.
Therefore, there are two options (0 and 1) in the first few CAN options. The baud rate is
100K. Since there is no terminal resistor installed for this test, the baud rate should not
exceed 100K. If you really use it, you must add a terminal resistor of the corresponding
resistance value.
Figure 4.12 Parameter setting of the first channel CAN
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
16