Safety Compliance - AGFA Classic E.O.S. User Manual

Special instructions for the handling of chemicals
When handling chemicals, you must observe safety and environmental regula-
tions as well as the operating and warning instructions accompanying the chem-
icals.
Wear stipulated protective clothing and safety goggles.
When disposing of chemicals and waste water, you must comply with the local
regulations concerning waste water and environmental protection.
If chemicals get into your eyes, immediately rinse your eyes with cold water and
consult a physician.
Do not inhale vapor from chemicals. Make sure that there is sufficient ventilation
where the processor is installed, i.e. air exchange that is at least ten times the
space volume per hour.
Always comply with the installation instructions.
Regularly check all connections to the processor for tightness.
If liquid gets into the inside of the processor (due to spills), disconnect the pro-
cessor from the mains immediately and have the device cleaned thoroughly by
service personnel.

Safety compliance

This processor complies with the safety regulations EN 60950: 1997 (IEC 950)
and EN 60601-1-2: 1993, UL 1950 and CSA C22.2 No. 950 and with
the regulations on radio interference suppression EN 50081-1, EN 55011 and
FCC 47 Part 15, Subchapter B, Class A.
The non-return water connection system complies with DIN 1988.
8
1281C GB 20001204