Advertisement
LASERABLE SILICONE SLEEVE - Laser Engraving
SNW-RW | SNW-LBW | SNW-NBW | SNW-BW | SNW-PW
GENERAL LASER ENGRAVING PROCESS
Recommended Equipment & Accessories
• CO2 Laser Engraver
• Clean Towel
• Soap and water
• Tape to hold sleeve flat on laser bed
Jan-22
Laserable Silicone Sleeve
Advertisement
Table of Contents
Related Manuals for Johnson Plastics Plus SNW-RW
Summary of Contents for Johnson Plastics Plus SNW-RW
- Page 1 Laserable Silicone Sleeve LASERABLE SILICONE SLEEVE - Laser Engraving SNW-RW | SNW-LBW | SNW-NBW | SNW-BW | SNW-PW GENERAL LASER ENGRAVING PROCESS Recommended Equipment & Accessories • CO2 Laser Engraver • Clean Towel • Soap and water • Tape to hold sleeve flat on laser bed...
- Page 2 Recommended Settings- Laser Engraving 50-60W lasers Laser Power 30-40% Laser Speed 75-80% Resolution (DPI/PPI) 500-600 General Laser Engraving Instructions • Place the silicone sleeve onto the laser bed and align to the zero point on the laser bed. o Optional: Utilize a jig to help position and hold the silicone sleeve flat on the laser bed. o If jig is not available, use tape to help hold the silicone sleeves flat on the laser bed.
- Page 3 To order more of this product, see similar products and much more, please visit jpplus.com. For additional product support and troubleshooting, please contact JPPlus Advanced Support Team: • Phone: 419-500-4877 • Email: ast@jpplus.com • Schedule an appointment: https://jpplusadvancedsupport.setmore.com/ Jan-22...
Need help?
Do you have a question about the SNW-RW and is the answer not in the manual?
Questions and answers