Advertisement
CRYSTAL ORNAMENTS- Laser Engraving
LBKCH026 | LBKCH025 | KUS037 | LBKCH027 | LBKCH028 | LBKCH029
GENERAL LASER ENGRAVING PROCESS
Recommended Equipment & Accessories
• CO2 Laser Engraver
• Isopropyl alcohol and clean cloth
• Normal copy paper or paper towel
• Water or Window Cleaner
Recommended Settings- Laser Engraving
40W lasers
Laser Power
Laser Speed
Resolution (DPI/PPI)
Laser Engraving Crystal Ornaments
90-100%
30-40%
500-600 DPI
Advertisement
Table of Contents
Related Manuals for Johnson Plastics Plus LBKCH026
Summary of Contents for Johnson Plastics Plus LBKCH026
- Page 1 Laser Engraving Crystal Ornaments CRYSTAL ORNAMENTS- Laser Engraving LBKCH026 | LBKCH025 | KUS037 | LBKCH027 | LBKCH028 | LBKCH029 GENERAL LASER ENGRAVING PROCESS Recommended Equipment & Accessories • CO2 Laser Engraver • Isopropyl alcohol and clean cloth • Normal copy paper or paper towel •...
- Page 2 Recommended Settings- Laser Engraving 50-60W lasers Laser Power 70-80% Laser Speed 25-35% Resolution (DPI/PPI) 500-600 DPI General Laser Engraving Instructions • Place a piece of normal copy paper or clean dry paper towel on top of the glass/crystal surface. • Spray the piece of paper or paper towel liberally with window cleaner or water so that the paper/towel is soaked through completely.
- Page 3 Troubleshooting • The engraving is too light. o The laser power may need to be increased. o The laser speed may need to be decreased. o Check to ensure that the laser is focused properly to the surface of the wet paper/towel. o Make sure that the fill color of the artwork is set to 80% RGB Black.
Need help?
Do you have a question about the LBKCH026 and is the answer not in the manual?
Questions and answers