Advertisement
ALUMINUM ORNAMENT INSERTS - Sublimation
SUB101 | SUB102 | SUB103 | SUB104 | SUB105 | SUB106 | SUB107
GENERAL SUBLIMATION PROCESS
Recommended Equipment & Accessories
• Sublimation Printer
• Standard Flat Heat Press- Swing-away style press recommended
• Heat Tape
• Teflon sheet or Blowout paper
• Optional: Spray adhesive (for double-side printing)
Dec-21
Aluminum Ornament Inserts
Advertisement
Table of Contents
Related Manuals for Johnson Plastics Plus SUB101
Summary of Contents for Johnson Plastics Plus SUB101
- Page 1 Aluminum Ornament Inserts ALUMINUM ORNAMENT INSERTS - Sublimation SUB101 | SUB102 | SUB103 | SUB104 | SUB105 | SUB106 | SUB107 GENERAL SUBLIMATION PROCESS Recommended Equipment & Accessories • Sublimation Printer • Standard Flat Heat Press- Swing-away style press recommended •...
- Page 2 Recommended Settings Time 45-55 seconds Temperature 360-370°F Pressure Medium Sublimating both sides at the same time Increase press time to 100-110 seconds General Sublimation Instructions • Preheat the heat press to 360-370°F. Set the time to 45-55 sec., set pressure to medium. •...
- Page 3 is removed should then be placed over top of the inserted metal piece and pressed into place to encase the metal insert in the ornament. Tips and Tricks • For best image placement, utilize the product template found on the product page on JPPlus.com. •...
- Page 4 Templates and Images • Visit jpplus.com to find the product page for this item. The product template may be found under the Tech Docs and Downloads area of the page. To order more of this product, see similar products and much more, please visit jpplus.com. For additional product support and troubleshooting, please contact JPPlus Advanced Support Team: •...
Need help?
Do you have a question about the SUB101 and is the answer not in the manual?
Questions and answers