Subscribe to Our Youtube Channel
Related Manuals for JWA ANTHONY 71288
Summary of Contents for JWA ANTHONY 71288
- Page 1 ASSEMBLY INSTRUCTION ANTHONY 1 Seat Outdoor Swing ITEM CODE:71288 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
-
Page 2: Pre-Assembly Preparation
PRE-ASSEMBLY PREPARATION Before you start: 1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2. Take care when lifting. Product should be assembled as near as possible to the point of use 3. Ensure that you have all required contents for complete assembly 4. -
Page 3: Parts List
PARTS LIST... - Page 4 Step 1 You will need the following • Prepare a floor or benchtop with a protective blanket or cardboard. • Attach the connection bar(G) to the 2 arm part(A),Secure with bolt(M), threaded through washer(P) .Fasten with Allen as shown below. •...
- Page 5 Step 2 You will need the following • Attach the connection bar(F) to the 2 foot part(D)(E),Secure the bracket on the bar with bolt(J), threaded through washer(P) Fasten with Allen as shown below. • Repeat the step for other connection bar.
- Page 6 Step 3 You will need the following • Insert connection bar (I) to the plastic parts, thread bolt(K) from the outside of the plastic bar .Fasten with Allen key(S) as shown below. • You will need to repeat the step for each end.
- Page 7 Step 4 You will need the following • Connect finished part from previous step to the finished foot part,as show below.(H). • Thread bolt(O) from the outside through the foot part.Lock the inside with washer(P) and nut(Q). Fasten with Allen key(S) and Wrench (R), as shown below.
- Page 8 Step 5 You will need the following • Insert the seat panel(B) to finished arm part, as shown below. • Secure with bolt(N), threaded from the outside, through Seat(B). Place the plastic washer(T) between seat panel(B) and arm part (A). Lock the inside with washer(P) and nut(Q). Fasten with Allen key(S)and Wrench(R), as shown below .
- Page 9 Step 6 You will need the following • Attach the backrest to the finished fame. • Thread bolt(U) from the outside through the backrest.Lock the inside with washer(P) and nut(Q). Fasten with Allen key(S) and Wrench (R), as shown below. •...
- Page 10 Step 7 You will need the following • Secure with bolt(N), threaded from the outside, through backrest(C). Place the plastic washer(T) between arm part(A) and backrest(C). Lock the inside with washer(P) and nut(Q). Fasten with Allen key(S)and Wrench(R), as shown below . •...
- Page 11 Step 8 You will need the following • Secure the chair upper base to bottom part, as shown below. • Insert bolt(O) from inside as shown. Lock the other side the bolt with washer(P) and nut(Q), as shown below. • Fasten with Allen key(S) and wrench(R). •...
- Page 12 Assembly is complete...
Need help?
Do you have a question about the ANTHONY 71288 and is the answer not in the manual?
Questions and answers