Subscribe to Our Youtube Channel
Related Manuals for JWA CUETA 68232
Summary of Contents for JWA CUETA 68232
- Page 1 ASSEMBLY INSTRUCTIONS CUETA 5 Piece Outdoor Bar Setting ITEM CODE 68232 Imported by JWA Furniture Pty Ltd, Brisbane, QLD, Australia For any assistance with assembly or for missing parts, please refer to your receipt...
-
Page 2: Pre-Assembly Preparation
PRE-ASSEMBLY PREPARATION Before you start: 1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2. Take care when lifting. Product should be assembled as near as possible to the point of use 3. Ensure that you have all required contents for complete assembly 4. -
Page 3: Parts List
PARTS LIST Part A: Bar Table... - Page 4 Part A: Bar Table You will need the following Step 1 • Prepare a floor or benchtop with a protective blanket or cardboard. • Prepare 8x bolt kits buy threading bolt(A) through washer(B). • Place the table frame(1) on the surface with the bottom facing up. •...
- Page 5 Part A: Bar Table You will need the following Step 2 • Prepare 4x bolt sets by threading bolt(A) threaded through washer(B). • Insert the spreader bar(3) as shown below. • Secure with 2 bolt sets on each end, as shown below. Fasten with Allen key(C) •...
- Page 6 Part A: Bar Table Step 3 • With the aid of a second person,stand the table up the right way. • Push down on the table until it levels out. Do not lean beyond your own balance. • Once level, turn the table back over, fully fasten all the bolts with Allen Key(C). •...
- Page 7 PARTS LIST Part B: Bar Stool...
- Page 8 Part B: Bar Stool. Assemble one at a time. You will need the following Step 1 • Prepare 8x bolt kits buy threading bolt(A) through washer(B). • Place the seat panel(1) on the surface with the bottom facing up. • Attach one of the sides(2) to the seat panel(1), as shown below.
- Page 9 Part B: Bar Stool. Assemble one at a time. You will need the following Step 2 • Prepare 4x bolt kits buy threading bolt(B) through washer(C). • Insert one of the connecting rods(3), secure with 2 bolt sets on each end as shown below.
- Page 10 Part B: Bar Stool. Assemble one at a time. Step 3 • Stand the stool up the right way. • Push down on the stool until it levels out. • Do not lean beyond your own balance. • Once level, turn the stool back over, fully fasten all the bolts with Allen Key(D). •...
Need help?
Do you have a question about the CUETA 68232 and is the answer not in the manual?
Questions and answers