Advertisement
AVR11 engelsk manual
11/01/98 10:46
1. Press the
button on the front
POWER
panel
to turn the unit on. Note that
1
the ring surrounding the power switch
will turn green, the display will light and
the volume indicator mark
green.
If the unit thereby switches on to the
Standby mode (that's the case if it was in
Standby mode at switch off) it simply can
be switched on by pressing any input
selector on the front panel.
• If you wish to use the remote to turn
the unit on and off, you must first engage
the front panel power button. The unit
may then be turned on and off by
pressing the
STANDBY b
the remote. When using the remote the
unit is placed in a "standby" mode rather
than being totally shut off, and the ring
surrounding the power button will glow
amber.
• When you will be away from home for
an extended period of time it is always
best to turn the unit completely off using
the front panel power button.
2. Select the desired program source
using the input selector switches
name of the selected input source will
appear in the information display
window. When the tuner is in use, the
selected station's frequency or RDS data
will be displayed.
Side 10
Operation
• When the selected input source is VCR1
or VCR2, the video signal for that input
will be switched to the
MONITOR OUT
viewable on a TV Monitor connected to
the AVR11. Be certain that your TV is set
Ó
will turn
to the proper "VIDEO" input to view the
signal.
3. Choose surround mode using the
mode select button
SURROUND
Consult the Surround Mode selection
section on page 8 for information on
surround modes. To listen to traditional
two channel (left/right) stereo press the
button.
BYPASS 3
4. Adjust the
CENTER MODE k
and/or
DELAY TIME h
button on
required from the setting established
during installation.
5. Adjust the volume to a comfortable
level using the front panel volume
control
or the up/down volume
Ô
controls on the remote
6. To temporarily silence the output to
the speakers press the
the remote
. Press the button again to
q
resume normal listening.
6
. The
7. For private listening, insert the 6,3 mm
stereo plug from a pair of headphones
into the
HEADPHONES
that when the headphones are plugged in
the sound from the speakers is
automatically cut off.
10
TUNER OPERATION
VIDEO
jack and will be
The AVR11's built in tuner is capable of
tuning AM, FM or FM Stereo broadcast
stations, and features the added benefits
of RDS operation. Stations may be tuned
manually, automatically or via presets.
.
4
Manual Tuning
1. Press the
the tuner as an input and the desired
frequency band.
2. Press the
so that the AUTO indicator in the display
is not on.
if a change is
3. Press the
until the desired station is tuned. Holding
the button down will cause a rapid
advance through the frequency band,
while tapping it lightly will advance
through bands one increment at a time.
.
n
4. Note that the
illuminate when a station is received with
button on
sufficient strength for quality reception.
MUTE
5. Press the
to switch between mono and stereo
reception. In cases where a station's
signal is weak, press the button until the
jack
2
. Note
indicator in the information
AUTO
display goes out. This will switch the
tuner to mono, but it may enable clearer
reception of the signal.
button
to select
6
FM/AM
button
SEEK/STEREO #
TUNING/PTY &
button
indicator will
T U N E D
button
SEEK/STEREO #
Advertisement
