Updating The Software; From Network (Over The Internet) - Logicube ZClone Xi Application Note

Application Note

5.2 Updating the software

There are two methods available to update/reinstall the ZXi software:
A. FROM NETWORK – Over the Internet through a network connection.
B. FROM USB DRIVE – Through a software file download onto a USB flash drive.

5.2.1 From Network (Over the internet)

The ZXi software can be updated/reinstalled by connecting the ZXi to a network with
Internet access.
1. Connect the ZXi to a network with Internet access and turn the ZXi on.
2. From the main menu on the ZXi, locate and tap the Software Updates icon on
the left side.
3. Select From Network. The ZXi will check for software on Logicube's server.
After a few seconds, one of the following messages will appear:
4. Tap the Update icon to begin the update/reinstall. The ZXi should begin the
update/reinstall process. Do not interrupt this process. It may take several
minutes. Once completed, a screen will appear stating the update is complete
and will prompt you to turn the unit off then back on.
5. Turn the ZXi off. Wait at least 5 seconds then turn the ZXi back on.
6. Verify the software version by going to the Software Updates screen then go to
section
ZClone Xi System Restore v1.2h
Revised date: 04/30/2021
Logicube, Inc. • 19755 Nordhoff Pl.,Chatsworth, CA 91311 USA• tel:+1-818-700-8488• fax:+1-818-435-0088
It is recommended to disconnect all
drives and drive adapters from the ZXi
before the update/reinstall process.
• Newer version available – This message will appear if there is a newer
software version found. Tap the OK icon to continue.
• Up to date – This message will appear if the software version found is
the same as the version currently installed. Tap the OK icon to continue.
•
No new version found – This message will appear if the ZXi does not
have any internet access. Tap the OK icon to continue. If this message is
seen, try the following:
i. Go to the About tab in the Statistics screen and check the N/W
Interfaces to make sure the ZXi is connected to a network and
has a valid IPAddress, or
ii. Make sure the network the ZXi is connected to has Internet
access, or
iii. Try using the "From USB DRIVE" option (see
6.0 Firmware Update
www.logicube.com
to check if there is a firmware update available.
Section 5.2.2).
Page 7 of 9