Creating The System Restore Usb Flash Drive - Logicube ZClone Xi Application Note

Application Note

3.0 Creating the system restore USB flash drive

Here are the steps to prepare the flash drive with the software necessary to be bootable:
It is recommended to use Chrome or Firefox
to download the files. Internet Explorer and
Edge do not download *.img files properly.
1. Go to http://updates.logicube.com/zxi-recovery/. Look for the following two files:
•
The ZXi image file (a file with a *.img extension)
• win32diskimager-v1.0.0-binary.zip – An open-source tool used for writing images to
USB flash drives or SD/CF cards
2. Download both files. If the image file will not download, right-click on the link and use the 'Save
Target As...' or 'Save Link As' option and make sure it is saved with the *.img file extension.
3. Extract all the files within the win32diskimager-v1.0.0-binary.zip file to a folder or directory of
your choosing.
4. Connect a USB flash drive that is at least 1 GB in capacity to the computer where the software
was downloaded. It is recommended that all other USB drives are unplugged.
The contents of the USB flash drive will be overwritten.
If there is data on the USB flash drive that should not be
deleted, back up the contents of the USB flash drive or
use another USB flash drive for this procedure.
5. In the win32diskimager-v1.0.0-binary folder where the software was unzipped, run the file
Win32DiskImager.exe. The Win32 Disk Imager window will appear.
ZClone Xi System Restore v1.2h
Revised date: 04/30/2021
Logicube, Inc. • 19755 Nordhoff Pl.,Chatsworth, CA 91311 USA• tel:+1-818-700-8488• fax:+1-818-435-0088
www.logicube.com
Page 2 of 9