Related Manuals for DIGITEN WTC200
Summary of Contents for DIGITEN WTC200
- Page 1 USER MANUAL Wireless Thermostat WTC100 WTC200 www.digit-en.com service@digit-en.com...
-
Page 2: Remote Controller
FEATURES • Easy to set with memory function • Plug and play, work with 100-240V AC • Display current temperature • Display set temperature (run temperature and stop temperature) • Automatic cooling or heating • Manually turn on / off function •... -
Page 3: Specifications
LCD display Specifications WTC100 WTC200 Receiver voltage requirement 100-240V AC Load capacity 100-240VAC 13A, 1500W@110VAC, 2500W@220VAC Remote batteries 2PCS 1.5V AAA, standby for 6 months requirement Transmission distance 100m（open space） Measuring temperature -10.0 ° C ~ 80 ° C, 14 ° F ~ 176.0 ° F... -
Page 4: Cooling Mode
Measure temp Resolution ±0.1°C /°F Control Precision ±1°C /°F High and low temperature 0-80°C alarm Remote control refresh 20 Seconds frequency Temperature probe Built in remote Receiver with 2m/6ft NTC probe Put in or replace the Battery 1.2 AAA size batteries are needed for the remote. Make sure they are put in right direction 2.When the low battery warning appears, please change batteries. -
Page 5: Heating Mode
cooling operation stops, the relay has no output, the LCD displays , the green light on the receiver is off. When the CURRENT value rises to the RUN value, the cooling operation starts, the LCD displays , the green light on the receiver is on. -
Page 6: Restore Factory Settings
1. Press and hold the SET button until the corresponding value flashes. At the same time, the is displayed on the LCD. Press the button to change the number. Short press SET button to set next valve, or long press the SET button to exit and save. use this method to set the RUN /STOP /Delay/ HIGH /LOW value respectively. -
Page 7: Troubleshoot
4.2, the measured temperature exceeds the measurement range, the current value shows HH (high temperature), LL (low temperature) WARRANTY The DIGITEN products are guaranteed to the original owner for one year against defects in workmanship and materials. Please contact us: service@digit-en.com www.digit-en.com/support... - Page 8 § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. §...
Need help?
Do you have a question about the WTC200 and is the answer not in the manual?
Questions and answers