Table of Contents
Advertisement
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Resetting the Switch Configuration
Caution
Accessing Help Online
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
OL-14317-01
This section describes how to reset the switch configuration by rerunning the
initial configuration dialog (System Configuration Dialog). These are reasons
why you might want to reset the switch:
You installed the switch in your network and cannot connect to it because you
•
assigned the wrong IP address.
You want to clear the configuration from the switch and assign a new IP
•
address.
Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
At the switch prompt, enter enable and press Return or Enter.
•
At the privileged EXEC prompt (
•
Return or Enter.
The switch displays the prompt to run the initial configuration dialog. See the
"Configuring the Switch" section on page 12
information and to set up your switch.
For a solution to your problem, look in the troubleshooting section of the
hardware installation guide or the software configuration guide on Cisco.com.
You can also access the Cisco Technical Support and Documentation website for
a list of known hardware problems and extensive troubleshooting documentation.
) enter setup, and press
switch#
to re-enter the configuration
Accessing Help Online
29
Advertisement
Table of Contents
