Cisco Catalyst 3032 Getting Started Manual page 25

Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Connecting the StackWise Plus Cables
Step 1
Step 2
Step 3
Caution
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
OL-14317-01
Planning and Creating a Switch Stack (Only 3130G-S and 3130X-S Switches)
Follow these steps to connect the StackWise Plus cables:
Remove the dust covers from the StackWise Plus cables, and store them for
future use.
Verify that cables are aligned as shown in
Figure 8 Inserting the StackWise Plus Cable
Insert one end of the cable into the StackWise Plus port on the front panel of the
switch. Insert the other end of the cable into the connector on the other switch (see
Figure 8).
Always use a Cisco-approved StackWise Plus cable to connect the switches.
When you remove the StackWise Plus cables from the connectors, replace the dust
covers to protect them from dust.
Removing and installing the StackWise Plus cable can shorten its useful life. Do
not remove and insert the cable more often than is absolutely necessary.
Figure 8.
S T K
B
A
1 8 X
1 7 X
2 0 X
1 9 X
2 2
2 1
25