Configuring The Switch Module - Cisco Catalyst 3030 Getting Started Manual

Cisco Catalyst Blade Switch 3030 Getting Started Guide

Configuring the Switch Module

Note
Connecting through the Switch Module Console Port
Step 1
78-17052-01
To run the system configuration dialog, you must first connect the switch to a PC
to run a terminal emulation program. There are two ways you can connect the PC
to the switch: either through the switch console port or through the DRAC/MC
console port. Instructions for these two procedures are included in this section.
If you connect to the switch through the DRAC/MC, the switch console port is
disabled. After you have completed the configuration procedure, you must use the
disconnect command to close the active console port and re-enable the switch
console port. Type logout to log out of the switch, then type ~. to disconnect the
DRAC/MC from the switch.
Follow one of these procedures:
To run the terminal emulation program through the switch module console
•
port, go to "Connecting through the Switch Module Console Port" section on
page 1-9.
To run the terminal emulation program through the DRAC/MC port, go to
•
"Connecting through the DRAC/MC" section on page
Follow these steps when connecting through the switch module console port:
Connect one end of the console cable to the switch module console port. Connect
the other end of the cable to the serial port of the computer that is running the
terminal emulation application. (See
Installing the Switch Module in the Server Chassis
Figure 4.)
Cisco Catalyst Blade Switch 3030 Getting Started Guide
1-11.
1-9