Connect To The Switch Ports - Cisco Catalyst 3030 Getting Started Manual

Cisco Catalyst Blade Switch 3030 Getting Started Guide
Warning
Warning
Warning

Connect to the Switch Ports

Connect to the 10/100/1000 Ports
Step 1
78-17052-01
Ultimate disposal of this product should be handled according to all national
laws and regulations. Statement 1040
For connections outside the building where the equipment is installed, the
following ports must be connected through an approved network termination
unit with integral circuit protection: 10/100/1000 Ethernet. Statement 1044
Installation of the equipment must comply with local and national electrical
codes. Statement 1074
This section describes how to connect to the fixed switch ports and to the
SFP module ports.
Follow these steps:
The automatic medium-dependent interface crossover (auto-MDIX) feature is
enabled by default on the switch module. When the auto-MDIX feature is enabled,
the switch detects the required cable type for copper Ethernet connections and
configures the interfaces accordingly. (See Figure
Cisco Catalyst Blade Switch 3030 Getting Started Guide
Installation Warning Statements
7.)
1-19