Advertisement
Manual Maredo®
GT 300 REV 042 VibeShoe-Roller
SERIAL:
IMPORTANT NOTE:
The required (hydraulic) power depends on the working depth, soil
conditions, working speed etc. The condition of the triplex greensmower
and the ambient temperature determine the available capacity. Everybody
should check the greensmower during work if it isn't overloaded by
checking the heat built up and take the correct measurements.
MAREDO DOES NOT TAKE ANY LIABILITY FOR
GREENSMOWER DAMAGES.
Note:
For a safe operation it is essential, that the operator reads and
understands the manual of the Maredo head and the triplex
machine.
MAREDO BV, RIJKSSTRAATWEG 16, 3956 CR LEERSUM, THE NETHERLANDS
WWW.MAREDO-BV.COM
EN 1918
1
Advertisement
Table of Contents
Related Manuals for MAREDO GT 300
Summary of Contents for MAREDO GT 300
- Page 1 MAREDO DOES NOT TAKE ANY LIABILITY FOR GREENSMOWER DAMAGES. Note: For a safe operation it is essential, that the operator reads and understands the manual of the Maredo head and the triplex machine. MAREDO BV, RIJKSSTRAATWEG 16, 3956 CR LEERSUM, THE NETHERLANDS WWW.MAREDO-BV.COM...
- Page 2 10. Use only original MAREDO spare parts, in order to ensure the safe operation of the machine. 11. Never use the MAREDO in the dark, in heavy rains, on frozen grounds, stony conditions and/ or on slopes steeper than 30 degrees.
- Page 3 We, MAREDO, Rijksstraatweg 16, 3956 CR Leersum, The Netherlands, hereby declare fully on our authority, that the product: MAREDO GT 300, with serial number as indicated on the machine and in this manual, to which this declaration applies, has been manufactured in line with NEN- EN –ISO 14121-1:2007, according to the stipulations of The Machine Directive...
- Page 4 12. You can make curves with the heads during work, BUT DO NOT MAKE TIGHT CURVES. Damages to the units and green may appear. 13. CHECK THE (HYDRAULIC) DRIVE OF THE GREENSMOWER REGULARLY. DO NOT OVERHEAT THE (HYDRAULIC) DRIVE. MAREDO IS NOT RESPONSIBLE FOR DAMAGES TO THE GREENSMOWER.
- Page 5 Right to Left This point should always face towards the front side Next, we need a parts kit to mount the head to your triplex greensmower. Maredo has several kits available. Each kit comes with its own mounting instructions and partslist.
- Page 6 ADJUSTMENTS/ IMPORTANT NOTES. By changing the front + 2.9 mm roller position, the dis- tance of the shoe to the - 3.5 ground changes. - 6,8 mm So you can set it for a - 9.6 mm light or heavy job. The rear roller stays in the centre hole.
Need help?
Do you have a question about the GT 300 and is the answer not in the manual?
Questions and answers