Entering Administrator Mode - Cisco 1503 Software Manual

Configuring the Hub
Configuring the hub takes place in three major steps:

Entering Administrator Mode

1
Configuring IP and SNMP Parameters
2
Configuring the SNMP Management Station
3
All of the commands used in the configuration steps are fully explained in the section
"Command Summary" later in this chapter.
Entering Administrator Mode
Step 1
Step 2
Step 3
Step 4
3-8
Cisco Micro Hub User Guide
Connect a console by following the instructions in the section "Connecting the
CONSOLE Port" in the chapter "Installing Your Hub" or start a Telnet session
with the hub.
Turn the hub ON by setting the power switch to the ON ( | ) position.
After a few seconds, you will see the user prompt. Use the enable command to
enter administrator mode:
Hub> enable
After entering the command, you will be prompted to enter the administrator
password. If the administrator password has not been set, you can enter
administrator mode by pressing the Return key, as shown below:
Hub> enable
Password: <Return>
Hub#
If the administrator password has not been set, you should set it following
Note
the steps in the section "Setting the Administrator Password" earlier in this
chapter. Record the password in a secure location.
The pound sign (#) after the prompt indicates that you are in administrator mode
and can enter the commands to configure the hub for IP and SNMP parameters.