Hoshizaki SafeTemp FH1-AAC Parts List page 33

Title: G. Evaporator Assembly
Index
No. Description
1 Evaporator
2 Bracket-Evap Shroud (R)
2a T2 Screw
3 Bracket-Evap Shroud (L)
3a T2 Screw
4 Heater – Defrost
5 Thermostat – Defrost
5a T2 Screw
6 Bushing
7 Thermistor – Defrost
Thermistor – Clip
8 "Y" Joint
9 "Y" Joint
10 Clip – Support Evap (A)
11 Clip – Support Evap (B)
12 Clip – Support Evap (C)
13 Shield – Heat
14 Nylon Tie
Installation Instructions for Parts 10, 11, 12, & 13
1. The original heat shield must be removed. This can be done by lifting the evaporator up and
sliding the heat shield out.
2. The new heat shield (part #13) is then installed in the rotocast drain pan.
3. The clips are then slid onto the end plate on the evaporator. Support clips (part #12) are
installed onto the hairpin end of the evaporator as shown in the illustration.
4. The other support clips (parts #10 and #11) are installed on the return bend end (same side
as inlet andoutlet tubes) as shown in the illustration.
NOTE: All clips are shown in the illustration in the correct orientation for installation. The
parts are slid onto the evaporator bracket using the tab on the support clip.
Model: FH2-AAC(-HD)
Material or
Model Number Part Number
- 2A0636-01
SS 4A0545-01
4×8, SS 7P32-0408
SS 4A0548-01
4×8, SS 7P32-0408
- 3A0591-01
- 4A0954-02
4×8, SS 7P32-0408
- 420470-01
Thermistor is to be replaced
using kit HS-3540. Apply to all
aux. codes.
320418-01
- 4A1687-03
- 4A1687-02
- 4A2826-01
- 4A2827-01
- 4A2828-01
- 3A1853G01
- 8911-0150
K-0 M-6
to to
M-5 P-5 P-6
1 1 1
1 1 -
2 2 -
1 1 -
2 2 -
1 1 1
1 1 1
2 2 2
1 1 1
- - -
1 1 1
1 1 1
1 1 1
1 1
1 1
2 2
1 1
33
Required Number
P-7
to
Q-6
1
1
1
2
1
-
1
1
1
1
1
2
1
1