How To Clean; To Clean Floor; Cleaning Sealed Wood Floors - Hoover H2510 Owner's Manual

3-15
E
F
To replace lid, align tab (E) on lid
with hole on front of tank (F).
Snap latch over tabs (G) on back of
tank.
3-18
Replace filter lid. Press down firmly to
secure the seal.
6. After area is cleaned, move the
mode selector switch to PICK UP.
The agitator brushes are OFF and the
mop's suction will pick up the dirty
solution.
Move cleaner over the area to pick up
the dirty solution.
7. To continue cleaning another area,
move mode selector switch to
SCRUB. Repeat with steps 5 and 6.
NOTE: To extend battery charge, it
is recommended that a small area (2'
x 3') be cleaned completely in
SCRUB mode, then switch to PICK-
UP mode. Continue cleaning in 2' x 3'
areas, scrubbing first, followed by
pickup. Battery operating time will be
approximately 25-33 minutes if this
procedure is followed for cleaning
floors.
3-16
G
To replace tank, insert bottom of tank
into cleaner and pivot top portion until
it is locked in place.

To clean floor

tile, linoleum, etc.)
1. Vacuum floor.
2. Fill solution tank with HOOVER®
Floor-to-Floor™ Cleaner and water,
according to instructions for Figs. 3-5
through 3-11. Do not use pine or
solvent based cleaning concen-
trates in your cleaner. Do not use
any type of wax in your cleaner.
3. Lower handle to operating position.
4. Set mode selector switch to
SCRUB. This will turn the brushes
ON.
When switching between SCRUB and
PICKUP, it is not necessary to turn
the cleaner off. Simply move the
mode selector switch back and forth
between the two settings.
8. Empty recovery tank or clean the
filter when the motor sound becomes
higher in pitch and there is a loss of
suction (see "Automatic Shut-Off",
page 6).
To clean filter
3-17
Turn cleaner OFF.
Remove recovery tank and lid (Fig. 3-
12 & 3-13). Remove filter lid (A), then
remove filter. Remove loose debris
from filter by either brushing or tap-
ping the filter. The filter may also be
rinsed for additional cleaning. Allow
filter to air dry between uses.
3-19
(vinyl,
5. To release solution, squeeze trig-
ger (A). Slowly move cleaner forward
and backward over area (approx. 2' x
3' sections) to be cleaned. Squeeze
trigger to release solution as needed.
Overlap strokes by one inch to help
prevent streaking.
Cleaning sealed wood
floors
Your HOOVER Impulse™ cordless
power mop may be used to clean
wood floors that have been sealed
with a polyurethane coating and can
be cleaned with water.
CAUTION: To prevent damage to
wood floors, follow the flooring
manufacturer's cleaning recom-
mendations.
If using cleaner on sealed wood
floors, inspect floor surface for
worn finish, bare wood or separat-
ed joints. Do not use Impulse™
mop to wet clean sealed wood
floors if any of these conditions
exist.
A
A
Continued
7