Advertisement
Repair instruction
Problem
8. The robot does not clean and
warning indicator lights up
continuously.
9. The dustcontainer indicator is
blinking.
10. The robot runs backwards
when switched on and
warning indicator is blinking.
11. The robot cannot fi nd the
docking station.
Remark
In case of straight line driving
issues.
Preparing for use
• Place the docking station on a horizontal, level floor against a wall.
Note: Make sure that there are no obstacles or height diff erences 80 cm in front, 30 cm to the right and 100 cm to the
left of the docking station.
2
1
Cause
a. The dust container is not
present.
a. Dustcontainer is full or clogged. • Clean the suction opening and clean the
a. Cliff sensor or Front bumper-
sensor triggered.
a. There is not enough room for
the robot to navigate towards
the docking station.
b. The robot is still actively
searching.
c. The robot was not started from
the docking station.
a. Wheels are slipping.
1 0 0
c m
FC8776/01 / FC8776/31
Solution
• Place the dust container in the dust container
compartment properly. Make sure you close
the dust container cover properly.
dustcontainer.
• Start callibration procedure (see separate
chapter).
If problem still occurs after callibration
procedure, the pcb bumper need to be
replaced.
• Try to fi nd another place for the docking station.
See "Installing the docking station " in chapter
"Preparing for use ". (See below)
• Give the robot around 20 minutes to return to
the docking station.
• If you want the robot to return to the docking
station after a cleaning run, start it from the
docking station.
• Check and clean the wheels and both side
brushes.
After cleaned them, the robot will drive better in
a straight line.
3 0 c
m
20-25
Advertisement
