Advertisement
INSTALLATION
WARNING
CAUTION
The oven is fitted with a plug and must only be connected
to a properly installed earthed socket. The socket must
only be installed and the connecting cable must only be
replaced by a qualified electrician, in accordance with the
appropriate regulations.
If the plug is no longer accessible following installation,
an all-pole isolating switch must be present on the
installation side with a contact gap of at least 3mm.
The built-in cabinet must not have a rear wall behind
the appliance. Do not cover ventilation slots and air
intake points.
A gap must be maintained between the wall and the
base of the unit above. Refer to diagrams for details.
NOTE: Your appliance must be mounted on a flat
surface for the full width and depth of the product.
Built-in furniture – flush fit
Min airflow gap
at front 200cm
2
12
INSTALLATION
Min.
500mm
600mm
466mm
(+2)
A 50mm ventilation gap must be left between the built-in
cabinetry and wall with no back panelling on the cabinet
housing the microwave oven. A minimum ventilation gap
of 3.5mm must be left between the bottom of the front
trim and adjacent shelf/cupboard.
Failure to accommodate for this gap in the installation
can cause product malfunctions which are not covered
under warranty
Side view
External face
of cabinet
and/or door
20mm
Min 3.5mm
ventilation
gap below
trim
50mm
Min airflow gap
at front 200cm
2
Flush fit top view
infill panel
350mm max. length
20mm
Cupboard
door
Infill panels are recessed 20mm from the external cabinet
door to accommodate flush fit.
50mm
450mm
6mm packer
microwave
oven
Please note
packer must be
set back 20mm
from front trim to
avoid obstruction
of front vent.
Packer must be
secured to base
of cabinet.
Cupboard
600mm
door
Advertisement
