Download Print this page

Elecom M-VM600 User Manual page 9

Advertisement

US
FCC ID: YWO-M-VM600
FCC ID: YWO-EG01A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE; This equipment has been tested and found to comply with the limits for a Class B Digital Device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiated radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communication. However, there is no grantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by tuning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver -
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected -
Consult the dealer or an experienced radio/TV technician for help
NOTICE: The manufacture is not responsible for any radio or TV interference caused by unauthorized
modification to this equipment. Such modifications could void the user's authority to operate the equipment.
In order to make improvements to this product, the design and specifications are subject to change without
prior notice.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment. (Example - use
only shielded interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator
and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least 0.5 cm
from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
Responsible party (For FCC matters only)
Around The World Trading Inc.,
7636 Miramar Rd #1300, San Diego, CA 92126
elecomus.com

Advertisement

loading

This manual is also suitable for:

Eg01a