Table of Contents
Advertisement
IBM storage products
Type Y to select the FAT 32 file system. Type N to select the FAT 16 file system.
The following screen allows you to create partitions. If you have more than 1 drive there will be 5 options.
Option 5 allows you to select the drive you wish to partition.
Current fixed disk drive:
Choose one of the following:
1. Create DOS partition or Logical DOS Drive
2. Set active partition
3. Delete partition or Logical DOS Drive
4. Display partition information
5. Change current fixed disk drive
Enter choice:[1]
Press ESC to exit FDISK
Select option 1 to create a DOS partition. The screen below will appear.
Create DOS Partition or Logical DOS Drive
Choose one of the following:
1. Create Primary DOS Partition
2. Create Extended DOS Partition
3. Create Logical DOS Drive(s) in the Extended DOS partition.
Enter choice: [3]
Press ESC to return to FDISK Options
Select option 1 to Create a Primary DOS Partition. If this is to be the boot drive, set this partition to
"Active".
IBM Hard Disk Drive Technical Support Center
PC DOS Version 7.0
Fixed Disk Setup Program
Copyright IBM Corporation 1983-1994
FDISK Options
1
Page 17
version 1.0
Advertisement
Table of Contents
