Table of Contents
Advertisement
IBM storage products
41.28+/- 0.5
44.45+/- 0.25
Bottom mounting holes
You must ensure that the drive has sufficient air flow. Mount the drive in the system using 4 6-32 UNC
screws. The maximum screw length is 3.5 mm for the side holes and 6 mm for the bottom holes. Mount
the drive securely enough to prevent excessive motion or vibration.
If you are mounting your drive in a 5 inch bay, you may need to purchase mounting brackets from your
computer manufacturer for the drive to be mounted securely.
Step 5a: Connectors (68 pin drives)
After the drive has been carefully mounted, connect the SCSI cable and the power cable to the drive.
(Note that the SCSI connector and power connector are keyed for proper insertion.)
68 pin connector
Page 12
IBM Hard Disk Drive Technical Support Center
version 1.0
Advertisement
Table of Contents
