IBM Ultrastar 36Z15 Quick Installation Manual

IBM storage products

Quick installation guide

Ultrastar 36Z15
Ultra 160 SCSI
Models: IC35L036UWPR15
IC35L036UCPR15
IC35L018UWPR15
IC35L018UCPR15
Handling precautions
Ÿ
Do not open the electrostatic discharge (ESD) bag
containing the drive until required.
Ÿ
Do not apply pressure on the drive during handling
or installation.
Ÿ
To prevent damage from impact or vibration
always set the drive down gently.
Ÿ
Handle the drive carefully by the edges. Do not
touch the exposed printed circuit board or any
electronic components.
Ÿ
Do not cover the breather hole! Covering the
breather hole may result in loss of data.
Ÿ
Save the packaging materials including the ESD
bag in the event that the drive must be returned.
Installing the drive
1. Backup all data.
2. Record the serial number and part number of your
hard drive for future reference.
3. Turn off the computer and remove the computer
system cover.
4. Before handling the hard disk drive, discharge any
static electricity from yourself and your clothing.
With one hand touch an unpainted metal surface
on the computer chassis, then touch the ESD bag
with the other hand for a minimum of two seconds.
5. Remove the hard drive from the ESD bag.
6. Unplug the computer.
7. Assign a SCSI address (0 through 15) to the drive
by installing a jumper on the appropriate ID bits
(pin pairs D, E, F, and G) on jumper block J4 as
shown on the shaded area in the following
illustration.
Address 6 is the shipping default for 68-pin models
Address 7 is normally reserved for the host adapter
IBM Technology Group Support Center
Address jumper and drive option blocks
8. Select the desired options by placing a jumper on
the pin pair for that option. The options are listed
below cross-referenced by a letter to the two
jumper blocks in the above illustration. Refer to
the Ultrastar 36Z15 product summary for a
description of the options.
A Pin pair for LED connection
B Termination Power (68-pin model only)
C Force Single-ended Mode
H (68-pin model) Enable Auto Spin
(80-pin model) Disable Auto Spin
I Auto Start Delay
J Delay Start 6/12
K Disable Parity
L Target Initiated Sync Negotiation
M Disable Unit Attention
N Reserved
Page 1
version 1.0