Removal Of Parts For Cleaning And Sanitizing - Sub-Zero UC-15I Maintenance Manual

Model UC-15I (Undercounter Ice Machine)
REMOVAL OF PARTS FOR CLEANING
AND SANITIZING
Removal of parts for the recommended annual cleaning
and sanitizing should be performed by a qualified serv-
ice technician only.
Before beginning to remove components, perform an in
place cleaning as described on page 4-3. The clean
cycle takes about 30 minutes. When the clean cycle is
complete, disconnect power to the unit and switch off
the water supply. Also read the entire Disassembly
Cleaning / Sanitizing procedure on page
DISCONNECT ELECTRIC POWER TO THE ICE
MACHINE BEFORE PROCEEDING.
Top Cover Removal
To remove the top cover
1. Extracting two screws along the back of cover.
2. Lift back edge of the top cover up slightly.
3. Pull top cover towards rear of unit until the retaining
clips at front disengage from top cover, then lift it off
of the unit.
Splash Shield Removal
The splash shield is held in place with the same screw
that secures the control box cover. To remove the
splash shield, the top cover will first need to be
removed, then extract the screw and lift the splash
shield straight up (See Figure
Water Shutter Assembly Removal
The water shutter assembly (consisting of evaporator
cover, water paddles and paddle rod) is designed to
keep the spraying water from escaping the
evaporator/spray bar enclosure. A steel rod which sup-
ports the water shutters sits in grooves molded into the
evaporator cover.
To remove the water shutter assembly, the top cover
will need to be removed first, then
1. Reach inside bin area and pull evaporator/spray bar
enclosure forward approximately 1/2" (13 mm).
2. Grasp both ends of evaporator cover and lift
assembly straight up.
3. The rod and paddles can now be pulled from the
grooves in the evaporator cover.
4-4.
(See Figure 4-8):
4-9).
(See Figure 4-10):
Screws
Figure 4-8. Top Cover Removal
Screw
Splash
Shield
Figure 4-9. Splash Shield Removal
Evaporator
Cover
Figure 4-10. Water Shutter Assy Removal
4-5
Maintenance/Cleaning/Adjust
Paddles
#7012423 - Revision B - May, 2011